Newton Exports Galvanized Stay Cable Strand

Newton Exports rolls out the Newton Exports Galvanized Stay Cable Strand to serve stay cable systems on cable-stayed and suspension bridges, where individual high-tensile wires are hot-dip galvanized before being bundled into the finished cable.

Tested and approved to ASTM A416 / EN 10138 (base) + hot-dip galvanizing, the strand family covers wires drawn and stabilised to the same high-carbon chemistry as Newton Exports’ bare LRPC strand, then hot-dip galvanized and bundled to the cable configuration the bridge designer specifies.

Structural engineers deploy the Newton Exports Galvanized Stay Cable Strand in cable-stayed bridge pylons and suspension bridge main cables, typically procured alongside the anchorage hardware and stressing jacks this guide lists as companion products.

Packaging for the Newton Exports Galvanized Stay Cable Strand follows sourcing from whichever of Newton Exports’ Tier-1 partner mills – Tata Wiron, Usha Martin or JSW Steel – best matches the buyer’s lead time and volume, with every shipment lashed and timber-chocked to survive long ocean transit without coil damage or corrosion.

Like all prestressing strand, the Newton Exports Galvanized Stay Cable Strand needs careful site handling: cut only with an abrasive disc cutter or shear cutter, never with a flame or welding torch, since heat changes the steel’s microstructure and its mechanical properties. Coils should be unloaded with a crane rather than dropped off the vehicle, stored under cover on a raised platform away from direct ground or water contact, and protected with a vapour phase inhibitor if they will sit on site for an extended period before stressing.